Hirschmann RS20 User Manual

Setting up the Configuration
Environment
236
A.4 Preparing Access via SSH
Basic Configuration
Release 6.0 07/2010
Figure 78: Security alert prompt for the fingerprint
 Check the fingerprint to protect yourself from unwelcome guests. Your
fingerprint is located in the “Key” frame of the PuTTY key generator (see
fig. 77)
 If the fingerprint matches your key, click “Yes”.
PuTTY will display another security alert message for the warning threshold
set.
Figure 79: Security alert prompt for the warning threshold set
 Click “Yes” for this security alert message.
To suppress this message for future connection set-ups, select “SSH” in the
“Category” frame before you set up a connection in PuTTY. In the
“Encryption options” frame, select “DES” and then click “Up” until “DES” is
above the line “---warn below here --”. In the “Category” frame, go back to
Session and set up a connection in the usual way.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16