Hitachi 65 - Page 146

5. SPECIFICATION
5-14
Table 5-16 BIOS Setup menu list ( (3/3)
Top
menu
Setting item
Default value
Note
Power
After AC Power On
Auto
Specifies the action when the power to the
equipment is turned on.
Power On : When the power is turned on, the
OS is started automatically.
Stay Off : When the power is turned on, the
system goes into the soft power off
mode.
Auto : If the OS was running the last time the
power was turned off, the OS starts as in
the case of Power On. If the OS was not
running the last time the power was
turned off, the system goes into the soft
power off mode as in the case of Stay
Off.
If the backup battery runs out or the battery is
not connected and the power is off, the setting
is the same as Stay Off.
For details, see “PRECAUTION 11.
PRECAUTIONS ABOUT THE BIOS
SETTINGS”.
FAN failure detection
Enabled
Specifies whether the until will detect a fan
failure when the power is turned on.
Do not change this setting.
Power saving mode
Disabled
Specifies whether to launch the CPU in the
power saving mode.
Do not change this setting.
Boot
Boot Priority Order
1. SATA CD/DVD
2. USB CD
3. DRIVE1
4. DRIVE2
5. ATA HDD
6. PCI SCSI
! 7. OPTION PORT
! 8. USB HDD
9. Internal Shell
Do not change this setting.
Configures the priority order of the devices
from which an OS is booted.
Exit
Exit Saving Changes
-
Saves the changes you made in the setup into
the SPI-ROM and reboots the system.
Exit Discarding Changes
Discards the changes you made in the setup and
reboots the system with the configuration you
saved in the SPI-ROM last time.
Load Setup Defaults
Loads the BIOS default settings.
Default values are loaded but not saved in the
SPI-ROM. If you want to save the default
settings in the SPI-ROM, use “Exit Saving
Changes”.