92
(a) Remove the piping joints C and D, and install a new ink filter.
● If the position of piping is incorrect, it cannot be installed.
(C is on the center side of the ink filter and D is on the outside of it.)
● When installing the piping, rotate the piping joints C and D clockwise to lock them.
● A small amount of ink remains in the ink filter even after ink disposal. Take enough care not to
spill ink when handling the used ink filter.
(b) Place the ink filter as shown in the figure
below. (The piping D is on the right side.)
(c) Put the end of the print head in the beaker to
be ready for ink stream ejection.
[Removal of the piping joints]
[Installation of the piping joints]
To Next Page
Loading...
