93
Start ink refill.
● Press OK on the screen below, and the unit starts to refill the circulation route with ink.
● The ink is ejected from the nozzle after a while. After the ink is ejected, check the ink stream position.
[Ink filter replacement] screen ([Ink refill])
● To abort the ink ejection, press Abort and follow the displayed operation guidance. After the
completion of the abort process, you are returned to the [Circulation control] screen.
● When the abort process has been performed, select [Ink refill] on the [Circulation control] screen.
● If the message below appears during ink refill, the unit automatically enters the stop state.
[Failure was detected in level sensor, pump or solenoid valve. When ready, press <Start/Continue>.]
Press OK and select [Ink refill] on the [Circulation control] screen.
● If the same message occurs again, contact your nearest local distributor.
To Next Page
Loading...
