Hitachi UX2 - Page 141

117
(2) Remove the M4 screws (at 3 locations) attached to the main body.
(3) Install the cleaning unit stopper on one side of the Slide base, and fix it with two M3 screws. All the
parts are supplied as delivered items and accessories.
(4) Fix the Slide base to the main body with the supplied M4 screws (3 pieces).
NOTE
● Install the Cleaning Station with the rail facing up.
● Be careful for the loose screws. Looseness of the screws may cause rattling or dropping.
● Use the three screw holes on the upper side to fix the Slide base. The use of three screw holes
on the lower side may damage parts when the Cleaning Station is installed or removed.
M4 screw
Slide stopper
Slide base
M3 screw (2 pieces)
Rail
M4 screw (at 3 locations)
Slide base