Hitachi UX2 - Page 142

118
(5) Attach the M4 screws removed in Step (1) to their original positions.
(6) Align the Slide base with the grooves of the slide block, and slide the jig to install it.
(7) Install the cleaning unit stopper (one piece) on the Slide base, and fix the Cleaning Station with the
supplied M3 screws.
NOTE
● The M3 screw for fixing the cleaning unit stopper is a tapping screw. If the screw is tightened
excessively, the screw hole may be damaged.
Screws removed in Step (1)
Slide block
Groove
Slide Base
* Make sure to perform
Step (3).
Otherwise, Cleaning
station may drop.
Slide stopper
Slide base
M3 screws
(Tighten one of the
screws at 2
locations.)
Cleaning Station