Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
9744 pairsplit -S, unmap
snapshot, replace
snapshot
The command ended abnormally because the volume you specified
as the S-VOL was grouped with a datastore of Hitachi Storage
Provider for VMware vCenter.
9745 paircreate You cannot create the HTI pair because you specified a volume
other than a V-VOL as the HTI S-VOL.
9746 paircreate You cannot create the HTI pair because you specified a pool-VOL
as the HTI S-VOL.
9747 paircreate You cannot create the HTI pair because you specified a TC P-VOL
as the HTI S-VOL.
9748 paircreate You cannot create the HTI pair because you specified a TC S-VOL
as the HTI S-VOL.
9749 paircreate You cannot create the HTI pair because you specified a UR data
volume or journal volume in the intermediate site of 3DC
cascading configuration as the HTI S-VOL.
974A paircreate You cannot create the HTI pair because you specified a UR P-VOL
as the HTI S-VOL.
974B paircreate You cannot create the HTI pair because you specified a UR S-VOL
as the HTI S-VOL.
974C paircreate You cannot create the HTI pair because you specified a UR journal
volume as the HTI S-VOL.
974F All commands The command ended abnormally because the volume you specified
as the HTI S-VOL has an S-VOL Disable attribute.
9752 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because the Max LBA size of the
volumes you specified as the HTI P-VOL and S-VOL is different.
9753 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because the number of slots of
the volumes you specified as the HTI P-VOL and S-VOL is different.
9754 paircreate You cannot create the HTI pair because you specified a DP-VOL as
the HTI S-VOL.
9756 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified either of
the following for the HTI S-VOL.
• External volume for which the Data Direct Mapping attribute is
enabled.
• Volume belongs to a parity group for which accelerated
compression is enabled
9757 All commands The command ended abnormally because you specified a Volume
Migration V2 source volume as the HTI P-VOL.
For more information about using Volume Migration V2, contact
customer support.
9758 All commands The command ended abnormally because you specified a Volume
Migration V2 target volume as the HTI P-VOL.
For more information about using Volume Migration V2, contact
customer support.
975A All commands The command ended abnormally because you specified an SI P-
VOL as the HTI S-VOL.
975B All commands The command ended abnormally because you specified an SI S-
VOL as the HTI S-VOL.
CCI command reference for Thin Image 217
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English