Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
975C paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified a DP-VOL
for which the Data Direct Mapping attribute is enabled as the HTI
S-VOL.
975D All commands The command ended abnormally because you specified a Volume
Migration V2 source volume as the HTI S-VOL.
For more information about using Volume Migration V2, contact
customer support.
975E All commands The command ended abnormally because you specified a Volume
Migration V2 target volume as the HTI S-VOL.
For more information about using Volume Migration V2, contact
customer support.
976A paircreate An unavailable parameter (unsupported parameter) is specified in
the command.
976C pairsplit You cannot store the snapshot data because you have run the
command when the pair is suspended and blocked ("PSUE"
status).
976E pairsplit The snapshot data cannot be stored because the HTI P-VOL and a
TC S-VOL share the volume, and the status of the TC pair is
"COPY".
976F pairsplit Snapshot data cannot be stored because the HTI P-VOL and a UR
S-VOL share the volume, and the status of the UR pair is "COPY".
9772 paircreate The HTI pair cannot be created because you specified a UR delta
resync pair volume as the HTI S-VOL.
9774 paircreate The HTI pair cannot be created because the HTI P-VOL and an SI
P-VOL share the volume, and the MU number you specified for the
HTI pair is already used by the SI pair.
9777 paircreate The HTI pair cannot be created because the HTI P-VOL and an SI
S-VOL share the volume, and you specified MU number zero (0) for
the HTI P-VOL.
977A paircreate, pairsplit The command ended abnormally because the HTI P-VOL and an SI
P-VOL share the volume, and the SI pair was in the process of
resynchronization.
977B paircreate, pairsplit The command ended abnormally because the HTI P-VOL and an SI
S-VOL share the volume, and the SI pair status is not "PSUS".
977C pairresync -restore You cannot restore the HTI pair because the HTI P-VOL and an SI
P-VOL share the volume, and the SI pair is not split ("PSUS"
status) or is suspended and blocked ("PSUE" status).
977D pairresync -restore The HTI pair cannot be restored because the HTI P-VOL and an SI
S-VOL share the volume, and the SI pair is not split ("PSUS"
status).
977E pairsplit Snapshot data cannot be stored because the pool or the pool-VOL
is blocked.
9783 pairresync -restore You cannot restore the HTI pair because of one of the following
reasons:
• You are storing snapshot data for the HTI pair that you want to
restore using the consistency group to which the pair is
assigned.
• You are using the P-VOL of the HTI pair you want to restore as
the P-VOL for another HTI pair, and you are storing the
218 CCI command reference for Thin Image
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English