Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
FF6D paircreate The command ended abnormally because the specified P-VOL is
used by a cascaded pair.
FF72
paircreate, pairsplit,
pairresync,
pairresync -restore
The Thin Image pair task failed because a snapshot tree is being
deleted.
FF7A paircreate The Thin Image pair could not be created because the V-VOL
capacity exceeded the amount reserved for the pool.
FF7C paircreate The Thin Image pair whose snapshot data is stored in the DP pool
could not be created because system option mode 1120 is set to
ON.
This table lists the SSB2 codes when SSB1 is B980, the related CCI
command, and the cause of the error.
SSB2
CCI command Cause of error
B901 paircreate,
pairresync, pairsplit,
pairsplit -S
The specified port is for NAS Platform (system LU).
B903 paircreate,
pairresync
The selected resource belongs to NAS_Platform_System_RSG.
Notes on using Thin Image primary volumes as TrueCopy,
ShadowImage, or Universal Replicator pair volumes
The raidcom modify snapshot -snapshot_data create or raidcom modify
snapshot -snapshot_data clone CCI command might return the error code
EX_EWSTOT (timeout) and terminate abnormally when the status of a pair in a
Thin Image consistency group cannot be changed.
Following are possible reasons why the pair status cannot be changed:
• The Thin Image primary volume is used as a Universal Replicator S-VOL,
and you are reaching the UR journal volume capacity limit.
• The Thin Image license is invalid.
• The Thin Image pair volumes are blocked.
• The current status of the Thin Image pair does not allow the raidcom
modify snapshot -snapshot_data create or raidcom modify snapshot
-snapshot_data clone command to run on the pair.
• The current status of the Thin Image, ShadowImage, TrueCopy, or
Universal Replicator pair does not allow the raidcom modify snapshot -
snapshot_data create or raidcom modify snapshot -snapshot_data
clone command to run on the pair.
After resolving these error conditions, make sure that all pairs in the
consistency group are in "PAIR" status before running the raidcom modify
222 CCI command reference for Thin Image
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English