Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
97CF paircreate You cannot create the HTI pair because an HTI group is already
using the CG number you specified.
97D4 All commands The command ended abnormally because you are in the process of
turning off the power.
97D5 All commands You cannot run the command because even though the specified
serial number matches the virtual storage machine, the physical
storage system's serial number that corresponds with the virtual
storage machine's serial number does not match when the virtual
storage machine's serial number is specified for P-VOL and S-VOL.
97D6 All commands You cannot run the command because the model, serial number, or
virtual LDEV ID of the volume specified as P-VOL is being changed.
97D7 All commands You cannot run the command because the model, serial number, or
virtual LDEV ID of the volume specified as S-VOL is being changed.
97D8 All commands The pair operation was rejected because one of the following
conditions holds for the volume that is specified as the HTI P-VOL:
• The volume is used as a global-active device pair volume and
does not accept pair operations.
• The volume is specified reservation attribute of a global-active
device.
97D9 All commands The pair operation was rejected because one of the following
conditions holds for the volume that is specified as the HTI S-VOL:
• The volume is used as a global-active device pair volume.
• The volume is specified reservation attribute of a global-active
device.
97DA paircreate, map
snapshot
The command ended abnormally because the T10 PI settings for
the P-VOL and S-VOL did not match.
97DD unmap snapshot/
replace snapshot
The command ended abnormally because you specified a pair to
which an S-VOL is not assigned.
97DE map snapshot/
unmap snapshot/
replace snapshot
The operation failed because different DKCMAIN microcode
versions are mixed. Confirm DKCMAIN microcode version.
97DF map snapshot The command ended abnormally because you specified an S-VOL
that is assigned to a pair.
97F1 replace snapshot The command ended abnormally because the pair cannot be
identified from snapshot data and the P-VOL that you specified.
97F1 map snapshot/
replace snapshot
The command ended abnormally because you specified a pair to
which an S-VOL is assigned.
97FA unmap snapshot/
replace snapshot
The command ended abnormally because you specified an S-VOL
that is not assigned to a pair.
B912 paircreate, pairsplit,
pairresync
The HTI pair task failed because you specified the incorrect S-VOL.
B9A7 All commands You cannot retrieve the consistency group information because HTI
is not installed.
FF58 pairsplit, pairresync,
pairresync -restore
The command ended abnormally because the specified pair is a
cascaded pair.
FF59 paircreate The command ended abnormally because the specified P-VOL is
used by a cascaded pair.
CCI command reference for Thin Image 221
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English