Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
• You were in the process of creating a new snapshot group but
you reached the maximum number of snapshot groups that can
be created.
• You have specified a snapshot group which has reached the
maximum number of pairs allowed in a group.
97B7 paircreate You cannot create the HTI pair because the HDP pool is being
initialized.
97B9 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because the status of the pairs
using the P-VOL you specified is suspended ("PSUE" status).
97BD map snapshot/
unmap snapshot
The command ended abnormally because you specified a P-VOL
that is not an HTI P-VOL.
97BE map snapshot/
unmap snapshot/
replace snapshot
replace snapshot is
for VSP G1000,
G1500, and VSP
F1500
The command ended abnormally because you specified a volume
that does not exist.
97BF paircreate You cannot create the HTI pair from the consistency group to
which the specified snapshot group belongs because of one of the
following reasons:
• SI is using the specified consistency group.
• You have reached the maximum number of pairs that can be
created for a consistency group.
• A pair that uses the same P-VOL exists already in the specified
snapshot group.
97C2 All commands The command ended abnormally because you specified an MU
number outside the allowable range.
97C4 All commands The command ended abnormally because of one of the following
reasons:
• You have specified a pool that is neither an HTI pool nor a DP
pool.
• You have specified a pool that does not exist.
97C6 paircreate, pairsplit,
pairresync, or
pairresync -restore
The command ended abnormally because HTI is not installed.
97C7 paircreate You cannot create the HTI pair because the capacity of cache
management devices is insufficient.
97C8 paircreate You cannot create the HTI pair because the capacity of the volume
you specified as the P-VOL or the S-VOL of the HTI pair is more
than the supported size.
97CB All commands The command ended abnormally because you specified a pool that
is neither an HTI pool nor a DP pool.
97CD paircreate/map
snapshot
The command ended abnormally because you specified a
deduplication system data volume as the P-VOL of a Thin Image
pair.
97CE paircreate/map
snapshot
The command ended abnormally because you specified a
deduplication system data volume as the S-VOL of a Thin Image
pair.
220 CCI command reference for Thin Image
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English