Hitachi VSP G400 User Guide

SSB2 CCI command Cause of error
snapshot data of the latter pair using the consistency group in
which the pair is defined.
9786 All commands The command ended abnormally because you specified a global-
active device volume for quorum disk as the HTI P-VOL.
9787 All commands The command ended abnormally because you specified a global-
active device volume for quorum disk as the HTI S-VOL.
978A paircreate You cannot create the HTI pair using the consistency group ID
because of one of the following reasons:
• SI is using the specified consistency group ID.
• You have reached the maximum number of pairs that can be
created for a consistency group.
• A pair that uses the same P-VOL is assigned to the specified
consistency group.
978B paircreate You cannot create the HTI pair because the consistency group ID
you specified is not within range.
9790 paircreate You cannot create the HTI pair because you have specified a DP-
VOL that is undergoing accelerated compression as the HTI P-VOL.
9793 paircreate You cannot create the HTI pair because a DP-VOL that is
processing the Unmap command issued with system option mode
905 ON has been specified as the HTI P-VOL.
9796 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified a volume
that does not have a path definition as the HTI P-VOL.
9797 paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified a volume
that does not have a path definition as the HTI S-VOL.
97A1 paircreate If you have reached the maximum number of HTI pairs, you
cannot create new pairs.
97A2 paircreate, pairsplit,
pairresync,
pairresync-restore
The command ended abnormally because you specified a volume
that uses two mirrors in a three UR data center configuration as
the P-VOL.
97A3 paircreate, pairsplit,
pairresync,
pairresync-restore
The command ended abnormally because the volume specified as
the S-VOL uses two mirrors in a three UR data center
configuration.
97A4 paircreate You cannot create the HTI pair because you have specified a DP-
VOL in the initialization process as the HTI P-VOL.
97A5 All commands The command ended abnormally because you specified a volume
that was undergoing online data migration as the HTI P-VOL.
97A6 All commands The command ended abnormally because you specified a volume
that was undergoing online data migration as the HTI S-VOL.
97B4 paircreate You cannot create the pair and use the specified consistency group
because you have you have reached the maximum number of
consistency groups that can be created.
97B5 paircreate You cannot create the HTI pair for the specified P-VOL because the
maximum number of snapshot ID (MU number) was used.
97B6 paircreate You cannot create the HTI pair because of one of the following
reasons:
CCI command reference for Thin Image 219
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English