83
Galaxy 2 Series Installation Manual
02 Telephone No.1
Telephone number 1 must be entered. This is the main telephone number that the alarms are signalled to. Up
to 20 digits may be entered, including control modifiers.
Note on dial Attempts
After a dialling sequence the panel waits 25 seconds from the last digit dialled, for a kiss-on tone. If nothing is
received in that time, the call will be considered a fault call and that attempt terminated. Between redial at-
tempts, the panel will go back on hook for a minimum of five seconds and a maximum of 10. The system will
attempt to send the alarm signal calls for two minutes before generating a comms fail fault condition. The panel
will continue to send a message for a total of four minutes before giving up.
The B key is used to erase an existing telephone number. Each press deletes the last digit displayed.
03 Account No.
This is the site identifier. A unique account number must be entered, this can be up to a maximum of 6 digits
although 4 digits is the standard.
The B key is used to erase an existing number. Each press deletes the last digit displayed.
04 Receiver
The transmission destination can be set to one of two modes:
1 = Alternate
If alternate mode has been enabled using two phone numbers, then each call attempt will alternate between
Telephone Number 1 and Telephone Number 2. A comms fail condition will still occur 2 minutes after the
initial dial attempt, regardless of how many attempts have been made to each number.
2 = Dual
Reports to both numbers programmed in Telephone Number 1 and Telephone Number 2. The alarm must
be transmitted to both numbers.
05 Telephone No.2
A second telephone number is available to support Dual and Alternate dialling to a second destination
receiver. The programming is identical to Telephone Number 1.
The B key is used to erase an existing number. Each press deletes the last digit displayed.
56 - Comms (cont’d)
To Next Page
Loading...
