Honeywell RP2F Series - Chapter 2 - EZ-Print Commands; Bluetooth Commands

EZ-PRINT COMMANDS
EZ-Print can process these types of commands:
l
Line Print Mode
l
Easy Print Mode
l
Query
l
Bluetooth
l
Network
l
Wireless
EZ-Print cannot process these commands:
l
Download Fonts
l
Download Graphics
l
Erase All Downloaded Fonts
l
Retrieve Serial Parameters
l
Set Serial Parameters
l
Upgrade Firmware
Bluetooth Commands
Use Bluetooth commands to set up the Bluetooth configuration. There are two types
of Bluetooth commands you can send from the host: set (S) and query (Q). All
Bluetooth commands are preceded by the ESC character and you must send the
Commit command ({COMMIT}{LP}) to invoke all of the Bluetooth commands. These
commands are paired with replies. All of the replies are exactly the same as the
Bluetooth commands except:
l
there is no ESC character.
l
the parameter sections are replaced by status codes (0 = okay, non-zero = error).
If data follows a command, the letters are followed by a colon. Each configurable
parameter has a unique letter, followed by a colon, and then the data for that
parameter. Multiple parameters within a command are separated by a semicolon.
Multiple fields within data are separated by a comma. You must send all commands
EZ-Print Command Reference 7
CHAPTER
2