Returns this reply if the command is successful:
{SWF:I:0}
Set IP Configuration
Sets the IP (Internet Protocol) configuration to MANUAL, DHCP, BOOTP, or
DHCP+BOOTP.
Only users with administrative privileges can set this command.
Command
ESC{SWF:D:x}
where:
x is:
0: MANUAL
1: DHCP
2: BOOTP
3: DHCP+BOOTP (default)
Example
This command sets the IP configuration to manual.
ESC{SWF:D:0}
Returns this reply if the command is not successful:
{SWF:D:1}
Returns this reply if the command is successful:
{SWF:D:0}
Set Netmask
Sets the mask that describes the ”number of hosts” on the subnet. The set value is
used only if DHCP and BOOTP are off.
Only users with administrative privileges can set this command.
Command
ESC{SWF:M:x}
where:
x is in the form of n.n.n.n. And, n can be 1 to 3 digits.
EZ-Print Command Reference 33
To Next Page
Loading...
Need help?
General
