Honeywell RP2F Series - Set Mode; Set Power Mode

Example
This command sets the inner authentication type to MSCHAPv2.
ESC{SWF:IA:1}
Returns this reply if the command is not successful:
{SWF:IA:1}
Returns this reply if the command is successful:
{SWF:IA:0}
Set Mode
Sets the current wireless setting behavior of the printer.
Only users with administrative privileges can set this command.
Command
ESC{SWF:T:<sexp>}ESC EZ{COMMIT}{LP}
where the values of <sexp> are:
H: Adhoc. When Mode is set to Adhoc, these commands are also set:
l
Set WPA = Off (disable WPA)
l
Set WPA2 = Off (disables WPA2)
l
Set EAP Type = Off (clears any EAP settings)
l
Set Channel = a value from 1 to 14
P: Infra (default)
Example
This command sets the mode to Adhoc.
ESC{SWF:T:H}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:T:1}
Returns this reply if the command is successful:
{SWF:T:0}
Set Power Mode
Sets how the battery behaves when the printer is not in use. For more information
about battery power, see your printer user manual.
EZ-Print Command Reference 53