Set Default Router
Specifies the IP (Internet Protocol) address of the default router. The set value is used
only if DHCP and BOOTP are off.
Only users with administrative privileges can set this command.
Command
ESC{SWF:G:x}
where:
x is in the form of n.n.n.n. And, n can be 1 to 3 digits.
Example
This command sets the default router value to 192.168.1.1.
ESC{SWF:G:192.168.1.1}
Returns this reply if the command is not successful:
{SWF:G:1}
Returns this reply if the command is successful:
{SWF:G:0}
Set IP Address
Sets the IP (Internet Protocol) address for which the printer is recognized in a TCP/IP
based network. The set value remains after the printer is rebooted.
Only users with administrative privileges can set this command.
Command
ESC{SWF:I:x}
where:
x is in the form of n.n.n.n. And, n can be 1 to 3 digits.
Example
This command sets the IP address to 192.168.1.181. If the command is successful,
the printer sends {SWF:I:0} as a reply. Otherwise, it sends {SWF:I:1}.
ESC{SWF:I:192.168.1.181}
Returns this reply if the command is not successful:
{SWF:I:1}
32 EZ-Print Command Reference
To Next Page
Loading...
Need help?
General
