Example
ESC{SWF:V:1}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:V:1}
Returns this reply if the command is successful:
{SWF:V:0}
Set WEP
WEP (Wired Equivalent Privacy) is a security protocol used between two wireless
devices. It uses a secret key (40 or 104 bits long) to encrypt data sent using a wireless
device. By default, WEP is disabled.
Only users with administrative privileges can set this command.
Command
ESC{SWF:W:<sexp>}ESC EZ{COMMIT}{LP}
where values for <sexp> are:
1: On. When WEP security is enabled, these commands are also set:
l
Set WPA = Off (disable WPA)
l
Set WPA2 = Off (disable WPA2)
0: Off (default). Disables WPA security for the printer.
Example
ESC{SWF:W:1}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:W:1}
Returns this reply if the command is successful:
{SWF:W:0}
Set WEP Key
Sets the WEP (Wired Equivalent Privacy) key used to select what WEP key is used for
security.
Only users with administrative privileges can set this command.
58 EZ-Print Command Reference
To Next Page
Loading...
Need help?
General
