Honeywell RP2F Series - Chapter 3 - Honeywell Printer Commands; Allow Messages from Printer Quit ESCP

HONEYWELL PRINTER
COMMANDS
These commands are specific to Intermec printers and allow you to set some of the
same commands as Intermec Settings, retrieve printer information, or quit EZ Print:
l
Allow Messages From Printer
l
Quit ESC/P
l
Restore Factory Defaults
l
Retrieve Firmware Version
l
Retrieve Job Status
l
Retrieve Printer Status
l
Retrieve Sleep and Standby Timer Values
l
Set Dark Adjust
l
Set Low Battery Indicator
l
Set Media Sensitivity
l
Set Print Speed
l
Set Sleep and Standby Timers
Allow Messages From Printer
Turns on or off the ability to see error messages the printer generates to alert a user of an error
condition. Each error is only sent once from the printer.
Command
ESC{SSC:U:x}
where:
x is:
Y: Turns on the allow messages from printer command.
N (default): Turns off the allow messages from printer command.
Example
This command turns on the allow messages from printer option.
ESC{SSC:U:Y}
EZ-Print Command Reference 63
CHAPTER
3