where the values of <sexp> are:
0: Off
2: On
Example
ESC{SWF:W:2}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:W:1}
Returns this reply if the command is successful:
{SWF:W:0}
Set WPA2
WPA2 (Wi-Fi Protected Access 2) Setting enables WPA2 security for the printer. WPA2
is the Wi-Fi Alliance equivalent implementation of the IEEE 802.11i Standard. This
security uses AES (Advanced Encryption Standard) for encryption.
Only users with administrative privileges can set this command.
Command
ESC{SWF:W:<sexp>}ESC EZ{COMMIT}{LP}
where the values of <sexp> are:
0: Off
3: On. Enables WPA2 security for the printer. When WPA2 security is enabled, these
commands are also set:
l
Set Mode = Infra
l
Set WEP = Off (disable WEP)
l
Set WEP Key = 0
l
Set WPA = Off (disable WPA)
l
Set Authentication (Wireless) = Open
Example
ESC{SWF:W:3}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:W:1}
Returns this reply if the command is successful:
EZ-Print Command Reference 61
To Next Page
Loading...
Need help?
General
