Honeywell RP2F Series - Set Print Speed; Set Sleep and Standby Timers

{SSC:M:0}
Set Print Speed
Set the print speed. Actual printing speed may be different from print speed
parameter set inside the printer depending on printing condition and settings. In
general, slower printing speed will provide better print quality.
Command
ESC{SSC:PS:F1}
where:
F1 sets the print speed. Range is 50 to 75 (default).
Example
This command sets the print speed to 50.
ESC{SSC:PS:50}
Returns this reply if the command is not successful:
{SSC:PS:1}
Returns this reply if the command is successful:
{SSC:PS:0}
Set Sleep and Standby Timers
Sets the sleep and standby timers for the printer. The commands are only applicable
in LP mode. The set command must be followed by the commit command, <ESC>EZ
{COMMIT}{LP}.
Command
<ESC>{SPW:T:n1,n2}
where:
n1 is the value (in seconds) for the sleep timer.
n2 is the value (in minutes) for the standby timer.
Example
The command sets the sleep timer to 20 seconds and the standby timer to 30
minutes.
<ESC>{SPW:T:20,30}<ESC>EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
70 EZ-Print Command Reference