Command
Format Value Default
ASCII ESC C n n = 20
Hex 1B 43 n n = 14
where:
n represents the number of lines in the form. n is a single byte and the range is 1 to
255.
Set Interline Spacing
Sets the number of blank dot lines that are fed between character lines.
Command
Format Value Default
ASCII ESC A n n = 0
Hex 1B 41 n n = 0
where:
n is the number of blank lines added after completion of the current line and before
the next line begins printing. Range is 1 to 155.
Set Single-Wide Print
Prints the current font in single width.
Command
Format Value
ASCII SI
Hex 0F
See Also
Set Double-Wide Print
Network Commands
Use network commands to set up the network configuration. There are two types of
network commands you can send from the host: set (S) and query (Q). Set commands
can only be set by an allowed user while query commands can be set by all users.
This table lists the available network commands.
30 EZ-Print Command Reference
To Next Page
Loading...
