Honeywell RP2F Series - Set EAP Type

Example
This command sets the EAP password to "Friend."
ESC{SWF:PW:Friend}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:PW:1}
Returns this reply if the command is successful:
{SWF:PW:0}
Set EAP Type
Sets the EAP (Extensible Authentication Protocol) type to use for the 802.1x
authentication.
Only users with administrative privileges can set this command.
Command
ESC{SWF:ET:<sexp>}ESC EZ{COMMIT}{LP}
where values for <sexp> are:
0: OFF. If you set EAP Type to a value other than OFF, WPA_PSK is cleared, WEP_KEY
is set to "0", and Set Mode is set to INFRA.
1: TTLS. Changes the INNER_AUTH setting to a value more applicable to that specific
EAP type. Set Inner Authentication is automatically set to MSCHAPv2.
2: LEAP. Only uses open authentication and does not work with Network EAP.
3: PEAP. Changes the INNER_AUTH setting to a value more applicable to that specific
EAP type. Set Inner Authentication is automatically set to EAP/MSCHAPv2.
The valid values are LEAP, TTLS, PEAP, and OFF (where 802.1x is not used.)
Setting a value other than OFF or TTLS automatically clears TTLS_USER
Example
This command sets the EAP type to LEAP.
ESC{SWF:ET:2}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:ET:1}
Returns this reply if the command is successful:
{SWF:ET:0}
EZ-Print Command Reference 51