Function Parameter Reference Guide
150 UDC2300 Controller Product Manual 12/00
12.2.79 RESET (TIMER RESET CONTROL)
This prompt is part of the Timer Set Up group.
This selection determines how the timer will be reset.
Selections Definitions
KEY
Run/Hold key.
AL1
Alarm 1
12.2.80 RN HLD (RUN/HOLD KEY LOCKOUT)
This prompt is part of the Tuning Set up group.
This selection allows you to disable/enable the Setpoint Ramp/Program
RUN/HOLD key.
“LOCK” must be set to “None”.
Selections Definitions
DIS
Disable the RUN/HOLD key
ENAB
Enables the RUN/HOLD key
12.2.81 RPUNIT (ENGINEERING UNITS FOR RAMP SEGMENTS)
This prompt is part of the Setpoint Ramp/Program Set up group.
This selection determines the engineering units for ramp segments.
Selections Definitions
TIME
Hours:Minutes
EU-M
Rate - Engineering units per minute
EU-H
Rate - Engineering units per hour
12.2.82 RSPSRC (REMOTE SETPOINT SOURCE)
This prompt is part of the Control Set up group.
This selection determines what your Remote setpoint source will be when toggled by the
FUNCTION key or Digital Input.
Selections Definitions
NONE NONE—No remote setpoint.
INP2 INPUT 2—Remote Setpoint is Input 2.
To Next Page
Loading...
