HP 5130 EI series User Manual

101
Step Command Remarks
1. Restore the main next-startup
configuration file from a TFTP
server in user view.
restore startup-configuration from
src-addr src-filename
This command is not supported in
FIPS mode.
2. (Optional.) Verify that the
specified configuration file has
been set as the main
next-startup configuration file.
display startup
display saved-configuration
N/A
Deleting a next-startup configuration file
CAUTION:
This task permanently deletes the next-startup configuration file from all member devices. Before
performing this task, back up the file as needed.
Delete the next-startup configuration file if one of the following events occurs:
• After you upgrade system software, the file no longer matches the new system software.
• The file is corrupt or not fully compatible with the device.
You can delete the main file, the backup file, or both.
To delete a file that is set as both main and backup next-startup configuration files, you must execute both
the reset saved-configuration backup command and the reset saved-configuration main command.
Using only one of the commands removes the specified file attribute instead of deleting the file.
For example, if the reset saved-configuration backup command is executed, the backup next-startup
configuration file setting is set to NULL. However, the file is still used as the main file. To delete the file,
you must also execute the reset saved-configuration main command. After the file is deleted, the device
uses factory defaults at the next startup.
Perform the following task in user view:
Task Command Remarks
Delete next-startup configuration
files.
reset saved-configuration [ backup |
main ]
If neither backup nor main is
specified, this command deletes
the main next-startup
configuration file.
Displaying and maintaining configuration files
Execute display commands in any view.
Task Command
Display information about configuration
rollback.
display archive configuration
Display the running configuration.
display current-configuration [ configuration [ module-name ]
| interface [ interface-type [ interface-number ] ] ]

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)