116
Task Command
Remarks
Specify the reboot date
and time.
scheduler reboot at time [ date ]
By default, no reboot date or time is specified.
Specify the reboot delay
time.
scheduler reboot delay time By default, no reboot delay time is specified.
Scheduling a task
You can schedule the device to automatically execute a command or a set of commands without
administrative interference.
You can configure a one-time schedule or a periodic schedule. A one-time schedule is not saved to the
configuration file and is lost when the device reboots. A periodic schedule is saved to the startup
configuration file and is automatically executed periodically.
Configuration guidelines
• Make sure all commands in a schedule are compliant to the command syntax. The system does not
check the syntax when you assign a command to a job.
• A schedule cannot contain any of these commands: telnet, ftp, ssh2, and monitor process.
• A schedule does not support user interaction. If a command requires a yes or no answer, the system
always assumes that a Y or Yes is entered. If a command requires a character string input, the
system assumes that either the default character string (if any) is entered, or a null string is entered.
• A schedule is executed in the background, and no output (except for logs, traps, and debug
information) is displayed for the schedule.
Configuration procedure
To configure a one-time schedule for the device:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create a job.
scheduler job job-name By default, no job exists.
3. Assign a command to
the job.
command id command
By default, no command is assigned
to a job.
You can assign multiple commands
to a job. A command with a smaller
ID will be executed first.
4. Exit system view.
quit N/A
5. Create a schedule.
scheduler schedule schedule-name By default, no schedule exists.
To Next Page
Loading...
Need help?
General
