HP 5130 EI series User Manual

127
To restore the factory-default settings and states, use the following command in user view:
Task Command Remarks
Restore the factory-default settings
and states.
restore factory-default
This command takes effect after a
device reboot.
Displaying and maintaining device management
configuration
Execute display commands in any view and reset commands in user view.
Task Command
Display the system time, date, local time zone, and
daylight saving time.
display clock
Display the copyright statement. display copyright
Display CPU usage statistics. display cpu-usage [ slot slot-number [ cpu cpu-number ] ]
Display CPU usage monitoring settings.
display cpu-usage configuration [ slot slot-number [ cpu
cpu-number ] ]
Display historical CPU usage statistics in a chart.
display cpu-usage history [ job job-id ] [ slot slot-number
[ cpu cpu-number ] ]
Display hardware information. display device [ slot slot-number | verbose ]
Display the electronic label information of the
device.
display device manuinfo [ slot slot-number ]
Display the electronic label information of a power
supply. (On an HP 5130-24G-SFP-4SFP+ EI
Switch (JG933A).)
display device manuinfo slot slot-number power power-id
Display the operating statistics for multiple feature
modules.
display diagnostic-information [ hardware |
infrastructure | l2 | l3 | service ] [ filename ]
Display device temperature statistics. display environment [ slot slot-number ]
Display the operating states of fans. display fan [ slot slot-number [ fan-id ] ]
Display memory usage statistics. display memory [ slot slot-number [ cpu cpu-number ] ]
Display memory usage thresholds.
display memory-threshold [ slot slot-number [ cpu
cpu-number ] ]
Display power supply information. display power [ slot slot-number [ power-id ] ]
Display job configuration information. display scheduler job [ job-name ]
Display job execution log information. display scheduler logfile
Display the automatic reboot schedule.
display scheduler reboot
Display schedule information. display scheduler schedule [ schedule-name ]

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)