24
Ste
Command
Remarks
10. Specify the
terminal display
type.
terminal type { ansi | vt100 }
By default, the terminal display type is
ANSI.
The device supports two terminal display
types: ANSI and VT100. HP recommends
that you set the display type to VT100 on
both the device and the configuration
terminal. If either side uses the ANSI type,
a display problem such as cursor
positioning error might occur when a
command line has more than 80
characters.
11. Set the maximum
number of lines to
be displayed on a
screen.
screen-length screen-length
By default, a screen displays up to 24
lines.
A value of 0 disables pausing between
screens of output.
12. Set the size of the
command history
buffer.
history-command max-size value
By default, the buffer saves up to 10
history commands.
13. Set the session idle
timeout.
idle-timeout minutes [ seconds ]
The default is 10 minutes.
If there is no interaction between the
device and the user within the idle timeout,
the system automatically terminates the
user connection on the user line.
If you set the idle timeout to 0, the session
will not be aged out.
Logging in through Telnet
You can Telnet to the device to remotely manage the device, or use the device as a Telnet client to Telnet
to other devices to manage them.
By default, Telnet login is disabled on the device. To log in to the device through Telnet, you must perform
the following tasks:
• Log in to the device through any other method.
• Enable the Telnet server.
• Configure Telnet login authentication on the device.
NOTE:
Telnet login is not supported in FIPS mode. For more information about FIPS mode, see
Security
Configuration Guide
.
To Next Page
Loading...
Need help?
General
