HP 5130 EI series

45
Ste
p
Command Remarks
4. Enable command
accounting.
command accounting
By default, command accounting is
disabled, and the accounting server does
not record the commands executed by
users.
If the command accounting command is
configured in user line class view,
command accounting is enabled on all
user lines in the class. You cannot
configure the undo command accounting
command in the view of a user line in the
class.
Configuration example
Network requirements
As shown in Figure 23, users need to log in to the device to manage the device.
Configure the device to send commands executed by users to the HWTACACS server to monitor and
control user operations on the device.
Figure 23 Network diagram
Configuration procedure
# Enable the Telnet server.
<Device> system-view
[Device] telnet server enable
# Enable command accounting for user line AUX 0.
[Device] line aux 0
[Device-line-aux0] command accounting