HP 5130 EI series User Manual

135
Figure 44 Configuration file acquisition process (from a TFTP server)
Deploying and configuring servers for automatic
configuration
To implement automatic configuration, you do not need to perform any configuration on the device.
However, you must deploy DHCP, TFTP, and DNS servers and configure the servers to cooperate with the
device as follows:
• DHCP server—Assigns the device a set of parameters for automatic configuration, which might
include:
{ A temporary IP address.
{ A configuration file name or the URL of a configuration file on an HTTP server.
{ A TFTP server domain name.
{ A TFTP server IP address.
{ A DNS server IP address.
For more information about the DHCP server, see Layer 3—IP Services Configuration Guide.

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)