HP 5130 EI series User Manual

84
Step Command Remarks
5. Download or upload a file
in an IPv4 network.
tftp tftp-server { get | put | sget }
source-filename [ destination-filename ] [ dscp
dscp-value | source { interface interface-type
interface-number | ip source-ip-address } ] *
The source IP address
specified in this command
takes precedence over the
one set by the tftp client
source command.
Use this command in user
view.
Configuring the device as an IPv6 TFTP client
Step Command Remarks
1. Enter system view.
system-view N/A
2. (Optional.) Use an ACL to
control the client's access to
TFTP servers.
tftp-server ipv6 acl acl-number
By default, no ACL is used for access
control.
3. Specify the source IPv6
address for TFTP packets
sent by the TFTP client.
tftp client ipv6 source { interface
interface-type interface-number |
ipv6 source-ip-address }
By default, no source IPv6 address is
specified. The source address is
automatically selected as defined in
RFC 3484.
4. Return to user view.
quit N/A
5. Download or upload a file in
an IPv6 network.
tftp ipv6 tftp-server [ -i
interface-type interface-number ]
{ get | put | sget }
source-filename
[ destination-filename ] [ dscp
dscp-value | source { interface
interface-type interface-number |
ipv6 source-ipv6-address } ] *
The source IP address specified in this
command takes precedence over the
one set by the tftp client ipv6 source
command.
Use this command in user view.

HP 5130 EI series Specifications

General

Brand	HP
Model	5130 EI series
Category	Switch
Language	English