HP 5130 EI series User Manual

80
Maintaining and troubleshooting the FTP connection
Task Command Remarks
Display FTP commands on the FTP
server.
rhelp N/A
Display FTP commands help information
on the FTP server.
rhelp protocol-command N/A
Display FTP server status. rstatus N/A
Display detailed information about a
directory or file on the FTP server.
rstatus remotefile N/A
Display FTP connection status.
status
N/A
Display the system information of the FTP
server.
system N/A
Enable or disable FTP operation
information display.
verbose By default, this function is enabled.
Enable or disable FTP client debugging. debug
By default, FTP client debugging is
disabled.
Clear the reply information in the buffer. reset N/A
Terminating the FTP connection
Task Command
Terminate the connection to the FTP server without exiting FTP
client view.
• disconnect
• close
Terminate the connection to the FTP server and return to user
view.
• bye
• quit
Displaying command help information
To display command help information after you log in to the server:
Task Command
Display command help information
• help [ command-name ]
• ? [ command-name ]
Displaying and maintaining FTP client
Execute the display command in any view.

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)