HP 5130 EI series User Manual

137
HTTP server configuration guidelines
Create configuration files required for device automatic configuration on the HTTP server. For simple file
name identification, use configuration file names that do not contain spaces.
TFTP server configuration guidelines
Create configuration files and host name files required for device automatic configuration on the TFTP
server, including the default configuration file device.cfg. For simple file name identification, use
configuration file names that do not contain spaces.
To use the host name file network.cfg, perform the following tasks:
• Create a configuration file for each device on the TFTP server.
• Name the file in the format host name.cfg.
• Add a mapping entry in the format ip host host-name ip-address for the host name file.
For example:
ip host host1 101.101.101.101
ip host host2 101.101.101.102
ip host client1 101.101.101.103
ip host client2 101.101.101.104
If a device resides in a network different than the TFTP server, configure the UDP helper function on the
gateway. The gateway then changes the broadcast TFTP request from the device to a unicast packet and
forwards the unicast packet to the TFTP server. For more information about UDP helper, see Layer 3—IP
Services Configuration Guide.

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)