108
Ste
Command
Remarks
2. Specify main startup
images for each
subordinate device.
• Method 1:
boot-loader file ipe-filename
{slot slot-number } { backup |
main }
• Method 2:
boot-loader file boot
boot-package system
system-package [ feature
feature-package&<1-30> ]
slot slot-number { backup |
main }
• Method 3:
boot-loader update slot
slot-number
Skip this step if you have only one
device.
When you use method 3, make sure
you understand the following
requirements and upgrade results:
• If the master device started up with
main startup images, its main
startup images are synchronized to
the subordinate devices. This
synchronization occurs regardless
of whether any change has
occurred to this set of startup
images.
• If the master device has started up
with backup startup images, its
backup startup images are
synchronized to the subordinate
devices. This synchronization
occurs regardless of whether any
change has occurred to this set of
startup images.
• Startup image synchronization will
fail if any software image being
synchronized is corrupted or is not
available.
3. Save the running
configuration.
save
This step makes sure any configuration
you have made can survive a reboot.
4. Reboot the IRF fabric.
reboot
At startup, each device reads the
preloaded Boot ROM image to RAM,
and loads the startup images.
5. (Optional.) Verify the
software image settings.
display boot-loader [ slot
slot-number ]
Verify that the current software images
are the same as the startup software
images.
Displaying and maintaining software image
settings
Execute display commands in any view.
Task Command
Display current software images and startup
software images.
display boot-loader [ slot slot-number ]
To Next Page
Loading...
Need help?
General
