30
Ste
Command
Remarks
9. Set the session idle
timeout.
idle-timeout minutes
[ seconds ]
By default, the session idle timeout is 10 minutes
for all user lines.
If there is no interaction between the device and
the user within the idle timeout, the system
automatically terminates the user connection on
the user line.
If you set the idle timeout to 0, the session will not
be aged out.
10. Specify a command to
be automatically
executed when users
log in to the user lines.
auto-execute command
command
By default, no automatically executed command
is specified.
Using the device to log in to a Telnet server
You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 12 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. (Optional.) Specify the
source IPv4 address or
source interface for
outgoing Telnet packets.
telnet client source { interface
interface-type interface-number | ip
ip-address }
By default, no source IPv4
address or source interface is
specified, and the primary IPv4
address of the outbound
interface is used as the source
address for outgoing Telnet
packets.
3. Exit to user view.
quit N/A
4. Use the device to log in to
a Telnet server.
• Log in to an IPv4 Telnet server:
telnet remote-host [ service-port ]
[ source { interface interface-type
interface-number | ip ip-address } ]
[ dscp dscp-value ]
• Log in to an IPv6 Telnet server:
telnet ipv6 remote-host [ -i
interface-type interface-number ]
[ port-number ] [ dscp dscp-value ]
N/A
To Next Page
Loading...
Need help?
General
