To Next Page

To Previous Page

# Assign an IP address to VLAN-interface 2, the interface connected to the Telnet user.

<Switch> system-view

[Switch] interface vlan-interface 2

[Switch-Vlan-interface2] ip address 192.168.1.70 255.255.255.0

[Switch-Vlan-interface2] quit

# Assign an IP address to VLAN-interface 3, the interface connected to the RADIUS server.

[Switch] interface vlan-interface 3

[Switch-Vlan-interface3] ip address 10.1.1.2 255.255.255.0

[Switch-Vlan-interface3] quit

# Enable Telnet server.

[Switch] telnet server enable

# Enable scheme authentication on the user lines for Telnet users.

[Switch] line vty 0 15

[Switch-line-vty0-15] authentication-mode scheme

[Switch-line-vty0-15] quit

# Enable remote-then-local authentication for temporary user role authorization.

[Switch] super authentication-mode scheme local

# Create RADIUS scheme radius and enter RADIUS scheme view.

[Switch] radius scheme radius

# Specify the primary authentication server address 10.1.1.1, and set the shared key to expert in

the scheme for secure communication between the switch and the server.

[Switch-radius-radius] primary authentication 10.1.1.1 key simple expert

# Exclude the ISP domain name from the username sent to the RADIUS server.

[Router-radius-radius] user-name-format without-domain

[Switch-radius-radius] quit

# Create ISP domain bbb and enter ISP domain view.

[Switch] domain bbb

# Configure ISP domain bbb to use local authentication for login users.

[Switch-isp-bbb] authentication login local

# Configure ISP domain bbb to use local authorization for login users.

[Switch-isp-bbb] authorization login local

# Apply RADIUS scheme radius to the ISP domain for user role authentication.

[Switch-isp-bbb] authentication super radius-scheme radius

[Switch-isp-bbb] quit

# Create a device management user named test and enter local user view.

[Switch] local-user test class manage

# Set the user service type to Telnet.

[Switch-luser-manage-test] service-type telnet

# Set the user password to aabbcc.

[Switch-luser-manage-test] password simple aabbcc

# Assign level-0 to the user.

[Switch-luser-manage-test] authorization-attribute user-role level-0

# Remove the default user role network-operator.

[Switch-luser-manage-test] undo authorization-attribute user-role network-operator

[Switch-luser-manage-test] quit

Questions and Answers:

Need help?

Do you have a question about the HP 5130 EI series and is the answer not in the manual?

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)