HP 5130 EI series User Manual

72
Analysis
RBAC requires that a login user have a minimum of one user role. If the RADIUS server does not authorize
the login user to use any user role, the user cannot log in to the device.
Solution
To resolve the problem:
1. Use one of the following methods:
{ Configure the role default-role enable command. A RADIUS user can log in with the default
user role when no user role is assigned by the RADIUS server.
{ Add the user role authorization attributes on the RADIUS server.
2. If the problem persists, contact HP Support.

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)