5-46
General System Configuration
Enabling System Logging
The following example shows how to set an IP address for the receiving server
using the logging command.
The following example shows the settings.
[no] logging <_host >[_port] 9-32
show debug 9-33
show logging 9-33
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# logging 10.1.0.3
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show debug
Debug Logging:
Syslog Relay 10.1.0.3 (port 514)
ProCurve Access Point 530(config)#
Command Syntax CLI Reference Page
To Next Page
Loading...
