HP 530 User Manual

9-109
Command Line Reference
Wireless Interface Commands
Example
beacon-interval
This command configures the rate at which beacon frames are transmitted
from the access point. See
rate-limit (page 9-158) syntax for setting the broad-
cast/multicast rates and burst values (in packets per second).
Syntax
beacon-interval <value>
• value - The rate for transmitting beacon frames.
(Range: 20-2000 microseconds)
Default Setting
100. The default behavior is to send a beacon frame once every 100
microseconds (or 10 per second).
Command Mode
Radio Interface Configuration
Command Usage
The beacon frames allow wireless stations to maintain contact with the
access point. They may also carry power-management information.
Example
Related Commands
rate-limit (page 9-158)
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# channel-policy static 1
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# beacon-interval 150

HP 530 Specifications

General

Graphics	Intel GMA 950
Processor	Intel Core Duo T2050
RAM	512 MB, upgradable to 2 GB
Storage	80 GB HDD
Display	15.4-inch WXGA (1280 x 800)
Operating System	Windows XP Professional
Battery	6-cell Lithium-Ion
Optical Drive	DVD+/-RW
Ports	3 x USB 2.0, 1 x VGA, 1 x RJ-45, 1 x RJ-11, 1 x Headphone, 1 x Microphone
Wireless	802.11a/b/g