9-8
Command Line Reference
Overview
Overview
This chapter describes the commands provided by the Access Point 530 CLI.
The CLI commands can be broken down into the functional groups shown
below.
Command Group Description Page
General Initial commands for performing basic access point
tasks.
9-10
System Management Basic commands for performing basic status,
management, and performance tasks.
9-17
System Logging Commands Commands related to event logs on the system. 9-31
System Clock Commands Commands related to SNTP. 9-35
SNMP Commands for establishing SNMP community
settings.
9-37
Flash/File Commands Configures relating to resetting configuration and
factory files.
9-50
RADIUS Accounting/
Authentication Commands
Configures RADIUS accounting and authentication
parameters.
9-65
Radius Users Configures RADIUS users. 9-69
MAC Address Authentication Configures MAC parameters. 9-72
Filtering Commands Configures filtering settings. 9-87
Ethernet Interface Commands Configures Ethernet interface settings. 9-91
Wireless Interface Configures wireless parameters. 9-101
Wireless Security Configures wireless security settings. 9-125
Neighbor AP-Detection Configures access point detection settings. 9-137
Vlan Commands Configures management VLAN parameters. 9-147
QoS Configures Quality of Service parameters. 9-150
WDS Configures WDS settings. 9-159
STP Configures STP parameters. 9-166