5-55
General System Configuration
Setting Up Filter Control
Setting Up Filter Control
You can prevent communications between wireless stations associated to the
access point, only allowing traffic between stations and the wired network.
You can also prevent any wireless client from performing any access point
configuration through any of its management interfaces, including Web,
Telnet, or SNMP access.
Web: Setting Traffic Filters
The Special Features – Filters screen configures traffic filters.
The Web interface enables you to modify these parameters:
â– Inter-Station Blocking: Enables/Disables the blocking of communica-
tions between wireless stations. (The default is Disabled.)
â– Wireless Management Blocking: Enables/Disables the blocking of a
wireless station’s access to the access point. (The default is Disabled.)
â– [Update]: Updates the Filter settings on the access point.
Figure 5-13. Configuring Traffic Filters
To Set Traffic Parameters:
1. Click Special Features > Filters.
2. For Inter-Station Blocking, click Enabled.
3. For Wireless Management Blocking, click Enabled.
4. Click [Update].
To Next Page
Loading...
Need help?
General
