HP 530 - Network Management Application Commands

9-37
Command Line Reference
Network Management Application Commands
Network Management Application
Commands
These commands are used to configure Simple Network Management
Protocol (SNMP) and Link Layer Discovery Protocol which defines standards
for facilities network management..
Command Function Mode Page
SNMP
[no] snmp-server community
<comm> restricted |
unrestricted
Sets up the private community access
string to permit access to SNMP commands
GC 9-38
[no] snmp-server host
<host><comm>
Sets the system location string. GC 9-40
[no] snmp-server contact
<contact>
Sets the contact string. GC 9-40
snmp-server port <port> Sets the SNMP server port number. GC 9-42
[no] snmp-server trap <trap> Enables and disables SNMP traps. GC 9-43
show snmp-server Displays the status of SNMP
communications.
MC 9-45
SNMPv3
[no] snmpv3 enable Enables and disables SNMPv3 functions on
the access point.
GC 9-46
[no] snmpv3 user-name <name>
[auth <md5 | sha> <password>]
[priv <des | aes> <password>]
Adds and removes SNMPv3 users on the
access point.
GC 9-47
show snmpv3 Displays current SNMPv3 settings on the
access point.
GC 9-47
LLDP
[no] lldp Enables Link Layer Discovery Protocol
service on the device.
GC 9-48
show lldp Displays the Link Layer Discovery Protocol
service status on the device.
GC 9-48