HP 530 - Qos Commands

9-150
Command Line Reference
QoS Commands
QoS Commands
The QoS commands supported by the access point are listed below.
CAUTION The default WMM parameters settings are usually adequate for WMM opera-
tion. Incorrect WMM settings can adversely affect network performance.
Changes to WMM parameters should be reserved for someone with an
advanced knowledge of how WMM operates. For more on WMM, see the IEEE
802.11e standard.
Command Function Mode Page
qos ap-params
<voice|video|best-
effort|background>
{<[aifs <aifs>] [cwmin
<swmin>] [cwmax
<cwmax>] [burst
<burst>]}
Configure QoS-related parameters on the device
for this radio
IC-R 9-151
qos sta-params
<voice|video|best-
effort|background>{<[a
ifs <aifs>] [cwmin
<swmin>] [cwmax
<cwmax>] [txop-limit
<txop-limit>]}
Configure QoS-related parameters on the
wireless stations.
IC-R 9-153
[no] qos wmm
Enables using Wireless Multimedia Extensions
on this WLAN.
IC-R 9-155
show qos
Displays details about QoS settings on the device
and wireless client.
IC-R 9-156
[no] rate-limit <rate>
<burst>
Configures the maximum rate at which the
access point transmits multicast and broadcast
traffic.
IC-R 9-156