HP 530 - Wpa-Cipher-Aes; Wpa-Cipher-Tkip

9-134
Command Line Reference
Wireless Security Commands
wpa-cipher-tkip
This command enables Temporal Key Integrity Protocol for WPA on this
WLAN. The no command disables TKIP for WPA on this WLAN.
Syntax
wpa-cipher-tkip
no wpa-cipher-tkip
Default Setting
Enabled. This is the default CIPHER protocol.
Command Mode
WLAN Interface Configuration
Command Usage
• This is one of the authentication options required to establish proper
WPA-PSK or WPA-802.1X security.
• When both TKIP and AES authentication methods are set, both TKIP
and AES stations can associate with the access point. WPA stations
must have either a valid TKIP or AES Key to communicate.
Example
wpa-cipher-aes
This command enables Advanced Encryption Standard (AES) for WPA on this
WLAN. The no version of the command disables AES for WPA on this WLAN.
Syntax
wpa-cipher-aes
no wpa-cipher-aes
Default Setting
Disabled
Command Mode
WLAN Interface Configuration
ProCurve Access Point 530(radio1-wlan1)# wpa-cipher-tkip
ProCurve Access Point 530(radio1-wlan1)#