HP 530 User Manual

9-158
Command Line Reference
QoS Commands
rate-limit
This command configures the maximum rate at which the access point
transmits multicast and broadcast traffic. The no version of the command
disables rate-limiting on the radio.
Syntax
rate-limit <rate> <burst>
no rate-limit
• rate - The broadcast/multicast rate limit value in packets per second.
The no version is disabled for this parameter. Valid values are any
number greater than 0.
• burst - The broadcast/multicast rate burst value in packets per second.
This value specifies the length of time allowed for a packet burst. Valid
values are any number greater than 0.
Default Setting
Disabled. Rate-limit rate is 50, Rate-limit burst is 75.
Command Mode
Radio Interface Configuration
Example
Related Commands
beacon-interval (page 9-109)
ProCurve Access Point 530(radio1)# rate-limit 2 5
ProCurve Access Point 530(ratio1)#

HP 530 Specifications

General

Graphics	Intel GMA 950
Processor	Intel Core Duo T2050
RAM	512 MB, upgradable to 2 GB
Storage	80 GB HDD
Display	15.4-inch WXGA (1280 x 800)
Operating System	Windows XP Professional
Battery	6-cell Lithium-Ion
Optical Drive	DVD+/-RW
Ports	3 x USB 2.0, 1 x VGA, 1 x RJ-45, 1 x RJ-11, 1 x Headphone, 1 x Microphone
Wireless	802.11a/b/g