9-91
Command Line Reference
Ethernet Interface Commands
Ethernet Interface Commands
The commands described in this section configure connection parameters for
the Ethernet interface.
interface
This command configures the specified interface or enters the Interface
Configuration Context.
Syntax
interface <interface>
• interface - The name of the interface. I.E. ethernet
Default Setting
N/A
Command Function Mode Pag
e
interface <interface> Enters Ethernet interface configuration
mode
GC 9-91
enable Enables the interface. IC-E 9-92
disable Disables the interface. IC-E 9-92
description Specifies a human-readable description of
this interface.
IC-E 9-93
dns primary <server_1> Specifies the primary name server. GC 9-93
dns secondary <server_2> Specifies the secondary name server. GC 9-94
[no] ip address <<ip>
<mask> | <ip>/<bits> | dhcp>
Sets the IP address for the Ethernet
interface.
IC-E 9-95
[no] ip default-gateway <ip> Sets the static default gateway router for the
device.
IC-E 9-96
speed-duplex <auto|auto-
10|auto-100|10-half|100-
half|10-full|100-full>
Sets the mode of operation for the Ethernet
port.
IC-E 9-97
show ip Shows the ip status on the device. MC 9-97
show interfaces<interface> Shows the status for the Ethernet interface. MC 9-98
To Next Page
Loading...
