HP 530 - Group-Config; Group-Config Member-ID; Group-Config Name

9-62
Command Line Reference
Group Configuration
The following example enables the group configuration feature.
group-config name
The command sets the name of the group to which the access point will
belong.
Syntax
group-config <name <group-name>>
• name <group-name> - The name of the group to which the access point
will belong.
(Range: 1-40 alphanumeric characters)
Default Setting
None
Command Mode
Global Configuration
Example:
The following example specifies that the access point will belong to group
"WHBldg22".
group-config member-id
The command sets an optional string that identifies the access point within
the group. The member-id identifies the access point in the member list.
Syntax
group-config [member-id <member-id>]
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# group-config
ProCurve Access Point 530(config)#
write memory
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# group-config name WHBldg22
ProCurve Access Point 530(config)#
write memory
ProCurve Access Point 530(config)#