9-142
Command Line Reference
Adaptive Tx Power Control Commands
Adaptive Tx Power Control Commands
The commands described in this section configure parameters for Adaptive
Tx Power Control.
atpc
This command enables and disables Adaptive Tx Power Control on the
selected radio.
Syntax
[no] atpc
• no - Disables on the selected radio.
Default Setting
Disabled
Command Mode
Interface Configuration (Radio)
Command Function Mode Page
[no] atpc Enables and disables Adaptive Tx
Power Control on the selected radio.
(The default is Disabled.)
IC-R 9-142
[no] atpc avoid-other-aps Enables and disables the Avoid Other
APs function. (The default is Disabled.)
IC-R 9-143
[no] atpc rf-group-name
<name>
The name used to group APs for
Adaptive Transmit Power Control. (The
default is blank.)
IC-R 9-143
atpc adapt < ap | ap+clients > Chooses between AP mode and
AP + Client mode.
IC-R 9-144
atpc max-reduction <max-
reduction>
The maximum amount of power
attenuation, from 0-18dB. (The default
is 18dB.)
IC-R 9-145
show atpc Shows the current settings for ATPC. GC 9-145
To Next Page
Loading...
