A-18
File Uploads, Downloads, and Resets
Disabling the Access Point Push Buttons
Disabling the Access Point Push Buttons
Using the Web user interface and CLI described in this section, you can disable
the ability to use the push buttons on the back panel of the access point.
Web: Disabling the Push Buttons
The Access tab on the Management – AP Access screen allows enabling and
disabling of the push buttons on the access point. For details on configuring
other management controls see,
“Setting Management Access Controls” on page 5-9.
The Web interface enables you to perform these actions:
■ Factory Reset: Enables or disables button control access (back panel of
the access point) to a factory default file reset. (Default is Disabled)
NOTE You can not disable the factory reset if you already have disabled the Serial
Interface. See
“Setting Management Access Controls” on page 5-9.
■ Custom Reset: Enables or disables button control access (back panel of
the access point) to a custom config file reset.(Default is Disabled)
■ System Reset: Enables or disables button control access (back panel of
the access point) to a system reset. (Default is Disabled)
■ [Update]: Updates the management and button control modifications.
Figure A-4. Remote Access Tab - Button Access
To Next Page
Loading...
Need help?
General
