HP 530 - CLI: Setting the Transmit Power Reduction and Antenna Parameters

6-26
Wireless Interface Configuration
Modifying Antenna Settings
CLI: Setting the Transmit Power Reduction and Antenna
Parameters
CLI Commands Used in This Section
The following example shows how to set the transmit power reduction value,
establish an external antenna, and set the mode to Single on the access point.
The default mode is set to Diversity.
Command Syntax CLI Reference Page
tx-power-reduction <value> 9-115
antenna <external | internal> 9-106
antenna mode <diversity | single> 9-106
show radio 9-117
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# tx-power-reduction 5
ProCurve Access Point 530(radio1)# antenna external
ProCurve Access Point 530(radio1)# antenna mode single